Sub-zero PRO 48 Manuel d'utilisateur télécharger pdf (Page 13)

13

C

L

Anti-tip bracket centerline

PRO 48 INSTALLATION INSTRUCTIONS

To prevent the PRO 48 from tipping

forward and provide a stable installation,

the unit must be secured in place with

the anti-tip bracket shipped with the unit

IMPORTANT NOTE:

Placement of the anti-tip

bracket is critical to a stable installation. It

m

ust be installed exactly 660 mm from the

front of the face frame of the unit to the back

of the anti-tip bracket. Also, the centering line

o

n the lower flange of the anti-tip bracket must

be centered in the rough opening. Failure to

properly position the anti-tip bracket will

prevent it from engaging the unit. Be sure that

the anti-tip bracket is installed on a solid base.

Refer to the illustrations below.

IMPORTANT NOTE:

For a stable installation,

be sure to use all anti-tip bracket hardware as

instructed for wood or concrete floors to

properly secure the bracket.

Wood floors

Make sure that there are no electrical

wires or plumbing in the area which the

screws could penetrate.

WOOD FLOOR APPLICATIONS

Use the twelve #12 x 51mm wood screws and

the twelve #12 flat washers provided. Drill

pilot holes 5 mm diameter maximum and be

sure that the screws penetrate through the

flooring material and into the wall plate a

minimum of 19. Be sure that the screws hold

tight. Refer to the illustration below.

IMPORTANT NOTE:

If the wood screws do not

hit a wall stud in any of the upper holes on the

anti-tip bracket, use the provided

#8–18 x

31,75 mm wood screw

, #12 flat washer and

nylon zip-it wall anchor in its place.

IMPORTANT NOTE:

In some installations the

subflooring or finished floor may necessitate

angling the wood screws used to fasten the

anti-tip bracket to the back wall. Refer to the

illustration below.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

Commentaires sur ces manuels

Pas de commentaire