Sub-zero PRO 48 Manuel d'utilisateur télécharger pdf (Page 10)

10

ELECTRICAL REQUIREMENTS

A 220-240 V AC, 50/60 Hz, 10 amp circuit

b

reaker and electrical supply are required. A

separate circuit, servicing only this appliance,

is required. Locate the electrical outlet within

the shaded area indicated in the Installation

Specifications illustration on the previous

page.

The PRO 48 is equipped with a detachable

power supply cord with a 3-prong grounding

plug, which must be plugged into a mating

3-prong grounding-type wall receptacle. Follow

local codes and ordinances when installing the

receptacle.

IMPORTANT NOTE:

A ground fault circuit

interrupter (GFCI) is not recommended and

may cause interruption of operation.

IMPORTANT NOTE:

The PRO 48 is equipped

with an appliance inlet type device. This allows

easy replacement of the power cord. The appli-

ance inlet is located on top of the unit on the

compressor shroud.

Do not use an extension cord or two

prong adapter. Electrical ground is

r

equired on this appliance. Do not remove

the power supply cord ground prong.

The outlet must be checked by a qualified

electrician to be sure that it is wired with

the correct polarity. Verify that the outlet

provides 115 volts and is properly

grounded.

Always shut power off at the circuit

breaker before performing any installa-

tion, service or maintenance.

PRO 48 INSTALLATION INSTRUCTIONS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 75 76

Commentaires sur ces manuels

Pas de commentaire