Sub-zero PRO 48 Manuel d'utilisateur télécharger pdf (Page 17)

DOOR ADJUSTMENT

Check to make sure that both doors are

properly adjusted. If not, adjustments can be

ade to the cabinet and door hinges.

MPORTANT NOTE:

e sure the unit is

properly leveled before doing any cabinet or

door hinge adjustment.

CABINET HINGE ADJUSTMENT

The door must be removed to adjust cabinet

hinges. To remove the door, lift up the vent

portion of the top grille, open the door to

about 45° and lift the door off the cabinet

hinges. Remove the hinge pins.

PRO 48 INSTALLATION INSTRUCTIONS

Loosen the two cabinet hinge fasteners

/4 to

/2 turn. Refer to the illustration below. Rein-

tall hinge pins and door. Open the door and

using the Allen wrench provided, turn the

adjustment screw to relocate the cabinet

inge. Close the door and check alignment.

Repeat these steps until the door is properly

aligned.

Remove the door and hinge pins again and

tighten the two cabinet hinge fasteners. Rein-

stall hinge pins and door and close the vent

portion of the top grille.

Hinge pins may stick in the door rather

than the cabinet hinge and may fall out of

the door after a few seconds, which could

cause damage to floors or injury.

Cabinet hinge adjustment

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

Pas de commentaire

Sub-zero PRO 48 Manuel d'utilisateur Page 17